General Titanium Series Instruction Manual page 17

USING YOUR LASER (continued)
Tilt alarm
• Once the instrument has been levelled off the tilt
alarm can be enabled by pressing the tilt alarm
button. The tilt alarm indicator light will flash
continuously whilst active.
• If the instrument is disturbed while the alarm is
active the instrument will stop rotating and will
need to be powered off and on again to reset its
level position.
Setting up a manual grade / slope
• To create a manual grade / slope, press the
manual grade mode button on the laser control
panel or remote control. The instrument will now
be in manual mode with the X-axis active. The LED
X / Y axis indicator on the laser control panel will
display a solid light to indicate X-axis is selected.
• Press the grade adjustment arrow buttons on the
remote control.
17
• To change to the Y-axis, press the manual grade
mode button. The LED X / Y axis indicator on the
laser control panel will flash to indicate the Y-axis
is selected. The instrument can now be adjusted
on the Y-axis.
• Press the grade adjustment arrow buttons on the
remote control.
• To adjust the grade, press the manual grade
mode button to cycle between X and Y axis
• To cancel manual grade mode, and return to
normal levelling press the power button off and on
again to reset the levelling process.
i
When in manual mode the instrument will
not self level and correct for vibrations and/or
disturbances.
i
Grade adjustments can only be made by
pressing the grade adjustment arrow buttons
on the remote control.