Laser Safety Read the following safety instructions before attempting to operate this tool. Keep these instructions in a safe place or store in the carry pouch for future reference. WARNING! SAVE ALL WARNINGS & INSTRUCTIONS FOR FUTURE REFERENCE. Read and understand all instructions. Use the tool only with the Do not position the tool near a reflective •...
Item Checklist Please ensure the following items are included with your laser level. If anything is missing please contact your retailer. General ML-3DR Multi-purpose Laser glasses magnetic mount (red) INCHES Laser target Lithium-ion Indoor charger & Hard carry case (red)
Using the Laser Laser port Control panel Bubble vial Power / locking switch Laser port Locked position (power off) / Tilt lock function (manual levelling) Unlocked position (power on / self levelling) Battery cover door 5/8” x 11 tripod thread 1/4”...
Using the Laser (continued) POWER SUPPLY The instrument is supplied with one • li-ion battery packs as its power source. Charging the li-ion battery pack Insert the charger into the charging adaptor. • Connect the li-ion battery onto the charging adaptor.
Using the Laser (continued) SETUP Select a place as close as practical to the work • site. Ensure the location is clear of traffic. Place the laser on a level surface such as a • bench or mount. OPERATION Powering on (self-levelling) To turn the instrument on, slide the power •...
Using the Detector NOT INCLUDED The General ML-D3H (GMLD3HDC) detector and clamp can be purchased from your nearest General dealer. POWER SUPPLY The LED direction indicators will indicate the • position of the laser beam. The centre LED will The instrument is supplied with one 9v alkaline •...
Page 8
Using the Multi-purpose Mount Clamp Screw fixing point Magnets 1/4” thread 1/4” thread thumb screw Screw fixing point 5/8” x 11 thread OVERVIEW Mounting onto a magnetic surface Attach the instrument to the mount using the • thumb screw. Attach the mount to a metal surface, ensuring •...
Page 9
Using the Multi-purpose Mount (continued) Mounting via the clamp Attach the two mount pieces together via the • magnetic backing (Fig.9). Attach the instrument to the mount using the • thumb screw. Use the clamp to mount to a suspended ceiling •...
Using the Tripod NOT INCLUDED A tripod can be purchased from your NOTE: adjustment methods will vary on tripod nearest measurement tool dealer. The models. Always ensure that any locking levers are below instructions are generic only and unlocked before making adjustments and returned set-up methods may vary between models.
Trouble Shooting ERROR CAUSE & SOLUTION Check that the battery is charged. • Laser level does Check the battery compartment for signs of damage and not power on • ensure that the compartment and battery terminals are clean. Check that the battery is charged. Laser level does •...
Warranty This tool comes with a standard 3 year warranty. Extend the warranty of your laser level to 7 years by registering online. See website for terms and conditions. www.spoton.com.au/warranty-information All Spot-on measurement tools are carefully checked and tested to our precise quality assurance standards. We offer a warranty in accordance with the following conditions: 1.