General Titanium Series Instruction Manual page 15

USING YOUR LASER (continued)
HORIZONTAL MEASUREMENT SET UP
Level surface set up
• Select a place as close and practical to the work
site as possible, and ensure that the location is
clear of traffic.
• Place the laser level onto a reasonably level
surface with the lighthouse facing upwards.
Tripod set up
• Select a place as close and practical to the work
site as possible, and ensure that the location is
clear of traffic.
• Extend the tripod legs to the required height and
then spread the legs wide enough so that the
tripod platform is stable.
• Place the laser level onto the tripod with the
lighthouse facing upwards and thread the yoke
into the base until firm. Do not over tighten as this
may cause damage to the laser level or tripod.
15
VERTICAL MEASUREMENT SET UP
Level surface set up
• Select a place as close and practical to the work
site as possible, and ensure that the location is
clear of traffic.
• Place the laser level onto a reasonably level
surface with the control panel facing upwards.