Deletion Of Radio Codes - Genius SPRINT 11 SW Instructions For Use Manual

Pagina 0 SPRINT 11 SW
Guide for the installer
activated channel.
8. When 5 seconds have elapsed from memory-storage of the last radio control the control unit automatically exits the
learning stage.
9. To check if the radio control was correctly memory stored, wait for 5 seconds after sending the code.

11.3. Deletion of radio codes

To delete all the codes of the memory stored radio controls, go through the following procedure:
1. Press and hold down one of the two push-buttons OPA or OPB.
2. The relevant LED begins to flash.
3. After five seconds, the LED starts to flash at high speed.
After another five seconds, both LEDs, OPA and OPB, light up on steady beam.
4.
5. Release the push-button.
This operation is irreversible, and all radio controls associated with both the OPEN A and the OPEN B commands will be
deleted.
There are 6 control LEDs on the control unit that continuously supply information on the status of the safety devices, the limit
switches and the radio controls. The table below shows the meaning of the LEDs.
LED
OPA OPEN A radio command active
OPB OPEN B radio command active
FSW Safety devices free
STOP STOP command inactive
FCC Closure travel limit device engaged
FCA Opening travel limit device engaged
The bold print indicates the condition of the LEDs with the gate closed in rest position.
Sliding gearmotors use, as travel limits, a magnetic sensor that operates together with two magnets positioned on the gate
rack. Both magnets are suitably polarized and activate a contact only: the contact of the closing travel limit or the contact
of the opening travel limit. The magnet that activates the contact of the opening travel limit device is marked with an open
padlock, the contact that activates the closing travel limit is marked with a closed padlock. For the correct operation of the
control unit, the magnet with an open padlock must be positioned near the gate opening edge, vice versa the magnet with
the closed padlock must be positioned near the gate closing edge (see following image).
12. CONTROL LEDS
ON
13. POSITIONING THE TRAVEL LIMIT MAGNETS
OFF
OPEN A radio command inactive
OPEN B radio command inactive
Safety devices engaged
STOP command active
Closure travel limit device free
Opening travel limit device free