Genius BRAIN 15 Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Genius Manuals
  4. Control Unit
  5. BRAIN 15
  6. Instructions for use manual

Genius BRAIN 15 Instructions For Use Manual

Hide thumbs Also See for BRAIN 15:
Table of Contents

Advertisement

Quick Links

IstRuzIoNI peR l'uso - INstRuctIoNs foR use
INstRuctIoNs pouR l'usAgeR - INstRuccIoNes pARA el uso
geBRAuchsANleItuNg - gIds vooR de geBRuIkeR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BRAIN 15 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Genius BRAIN 15

Summary of Contents for Genius BRAIN 15

  • Page 1 IstRuzIoNI peR l’uso - INstRuctIoNs foR use INstRuctIoNs pouR l’usAgeR - INstRuccIoNes pARA el uso geBRAuchsANleItuNg - gIds vooR de geBRuIkeR...
  • Page 2 Eloigner de la portée des enfants les radiocommandes ou tout autre générateur GENIUS declines all liability caused by improper use or use other than that for which d’impulsions, pour éviter tout actionnement involontaire de l’automatisme.

  • Page 3: Table Of Contents

    2006/95/EC Low Voltage directive. • 2004/108/EC Electromagnetic Compatibility directive. Additional information: This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.). Grassobbio, December 30, 2009 Managing Director D. Gianantoni Notes on reading the instruction Read this installation manual to the full before you begin installing the product.

  • Page 4: Warnings

    BRAIN 15 Pagina 1 Guide for the installer 1. WARNINGS Before attempting any work on the control unit (connections, maintenance), always turn off power. Install, upstream of the system, a differential thermal breaker with adequate tripping threshold, Always separate power cables from control and safety cables (push-button, receiver, photocells, etc.). To avoid any electrical disturbance, use separate sheaths or a screened cable (with the screen earthed). 2. LAYOUT AND CONNECTIONS Fig. 1 a The power supply is related to the BRAIN 15 purchased version.

  • Page 5: Technical Specifications

    Different output values can be obtained on the board connected to the BRAIN 15 equipment. supply terminals depending on the mains voltage If the gate detects an obstacle during the opening or closing value.

  • Page 6: Start-Up

    Send an OPEN command to determine the start of the Before performing the Setup, select the operator con- decelerated part and wait until the opening mecha- nected to the BRAIN 15 equipment with the DS3 and nical stop point is reached. DS4 dip-switches.

  • Page 7: Installation Of Bus Accessories

    Pagina 1 BRAIN 15 Guide for the installer Leaf 2 starts the closing phase. Tab. 4 - Programming features Send an OPEN command to determine the start of the decelerated part and wait until the closing mechanical stop point is reached. Leaf 1 starts the closing phase.

  • Page 8: Addressing The Bus Photocells Page.17

    BRAIN 15 Pagina 1 Guide for the installer 7.1. Addressing the BUS photocells Tab. 5 - Addressing of BUS Photocells Dip1 Rif. Tipologia The same address must be given to both transmitter and receiver. Make sure that there are no two or more photocells pairs with the same address.

  • Page 9: Memory Storing The Radio Code

    Pagina 1 BRAIN 15 Guide for the installer to execute learning. The BUS LED flashes. Release both push-buttons. Give an OPEN impulse, leaves will move and the BUS Within these 5 sec., while the radio control LED is still learning procedure is over.

  • Page 10: Radio Controls Deletion Procedure Page.19

    BRAIN 15 Pagina 1 Guide for the installer cating memory storage executed, and then resumes flashing for 5 sec., during which other radio controls can be memory stored, and then goes OFF. 8.3. Radio controls deletion procedure To delete ALL the input radio control codes, press push-button LOGIC (SW3) or SPEED (SW2) and, while holding it down, also press push-button SETUP (SW1) for 10 sec.

  • Page 11: Function Logics

    Pagina 0 BRAIN 15 Guide for the installer 11. FUNCTION LOGICS Tab. 7 LOGIC “A” PULSES AUTOMATED OPEN A OPEN B STOP FSW OP FSW CL FSW CL/OP SYSTEM STATUS opens and clo- opens released no effect (OPEN no effect (OPEN no effect (OPEN ses after pause leaf and closes...
  • Page 12 BRAIN 15 Pagina 1 Guide for the installer Tab. 10 LOGIC “EP” PULSES AUTOMATED OPEN A OPEN B STOP FSW OP FSW CL FSW CL/OP SYSTEM STATUS opens released no effect (OPEN no effect (OPEN no effect (OPEN CLOSED opens the leaves no effect leaf disabled) disabled) disabled)
  • Page 13 Pagina  BRAIN 15 Guide for the installer Tab. 13 LOGIC “C” MAINTAINED COMMANDS PULSES AUTOMATED OPEN A OPEN B STOP FSW OP FSW CL FSW CL/OP SYSTEM STATUS no effect (OPEN no effect (OPEN no effect (OPEN CLOSED opens the leaves no effect no effect disabled) disabled) disabled)
  • Page 14 Les descriptions et les illustrations du présent manuel sont fournies à titre indicatif. GENIUS se réserve le droit d’apporter à tout moment les modifications qu’elle jugera utiles sur ce produit tout en conservant les caractéristiques essentielles, sans devoir pour autant mettre à...

Table of Contents