Instrument Options - Tektronix 213 DMM Instruction Manual

Section 7-213 Service
INSTRUMENT OPTIONS
Your instrument may be equipped with the following option, if it was ordered from the factory with the option installed.
If not, the option can be installed at a later date by contacting the closest Tektronix Field Office or representative.
OPTION 1
This option allows the instrument to charge the batteries or operate from a power line source of 180 to 250 V ac (48 to 62
Hz)
or 180 to 250
V
de. Refer to the parts list and Diagram 5 in this manual for information concerning C416 which is used
with Option 1 but not with the standard 213. Refer to Accessories page at the back of the manual for the power cord cable
assembly included with Option 1 for adapting to appropriate power plugs. Part number for the A5 board used with Option 1
is listed here.
A5 670-2226-21 CIRCUIT BOARD ASSEMBLY: POWER SUPPLY (OPTION 1)
REV APR 1982
7-1