Support Contact Details - Pyronix PCX 78 Installation Manual

Fault
WLs JAMMING Pnl
WLs Supervn Fault
WLs Input / Input Type
Mismatch
Wireless Keypad x WLs
Supervn Fault
Table 30 - Errors When Arming
Fault
Please leave via exit
door
Exit Via...
Unable To Arm
Alarm during the
arming
Alarm during the
arming procedure

Support contact details

Email: export.support@pyronix.com
Website: www.pyronix.com
PCX Installation Guide
Description
Jamming fault on the panel. Something is
jamming/interfering with wireless peripherals.
No 'supervision polls' were received for 20
minutes before the arming operation. Wireless
Input or Bell input number will be shown so the
problem is easily identified.
Wireless devices are learned on Inputs but no
zone types have been programmed for them.
No 'supervision polls' have been received by the
panel for 20 minutes or the length of the
'supervision timer'. Wireless keypad number will
be shown.
Description
If the exit mode is programmed as Entry Delay,
then you must leave through that door to arm
the system.
If any follow detectors or door contacts are
open during the arming procedure, this prompts
you to close them.
A fault condition exists on the system. Details of
the fault will scroll on the display.
Fail to arm time has been exceeded.
Instant Inputs have been activated.
102017852 - V01
Solution
Check no radio interference is in close proximity
to the radio devices/panel.
Test the signal strength / battery on each
wireless device
Program input type for each wireless device
learned in the PROGRAM INPUTS.
Test the signal strength and the battery on each
wireless keypad.
Solution
Leave via the agreed exit route.
Close all Inputs.
Correct the problem if it is an input which is
open, or call engineer.
Leave the premises within the fail to arm time,
increase the fail to arm time in timers or disable
this feature in system options.
During the arming procedure do not activate
instant Inputs.
79