Table of Contents
Advertisement
Then you can start the device by following these instructions:
10:25
12/10/12
ver
Ver 0.M.X.X
Controller when turned on
Note 1: LED on the display indicates the status of the appliance. If it blinks, it means that the device has no
operating instructions set up. If the LED is lit and not flashing, the system works according to the given
instructions.
Note 2: Restart the unit by switching off and repeated switching on by pressing the ON/OFF button.
5.5 OPERATING MODES
AQUA HP is programmed to run in three operating modes - ECO, AUTO and BOOST that are summarized
in the following table:
Mode
Symbol
ECO
AUTO
BOOST
BOOST
User can change the operating mode at will, all they need is to simultaneously press the MENU + OK/LOCK
keys for 3 seconds. Upon entry, use the COMP ▲ and E-HEATER ▼ keys to move in the menu and submenus.
To confirm the values/parameters press the OK/LOCK key. To exit the menu, press the CANCEL key.
5.5.1 ECO Mode
In the ECO operation mode, the device operates only as a heat pump heating water in a hot water tank.
It is thus possible to achieve greater efficiency and savings for user.
Every time the user deems it necessary, they can turn on a supporting heating element in this mode manually
by pressing the (E-HEATER) key.
and indicates this status on the display (including the heating element indication). If the heating element
is turned off manually, the appliance returns to the ECO mode.
10:25
ECO
The system is turned off (OFF)
Press the ON/OFF switch
ECO
Regular mode as heat pump
Optimised management of heat pump or electrical heating
AUTO
element run
Run of both the heat pump and the electrical heating element
ECO
This device automatically changes the operating mode to BOOST
12/10/12
45 ºC
Function
10:25
12/10/12
ECO
45 ºC
ON
ON
Press the COMP key to
start the system
- 22 -
Advertisement
Table of Contents
