Control Pads On The Dehumidifier; Control Pads - Carrier CDF-20Q7 Owner's Manual

CONTROL PADS ON THE DEHUMIDIFIER

CONTROL PADS ON THE DEHUMIDIFIER
NOTE: The control panel of the unit you purchased may be slightly different according to the models.
Timer indicator
Wireless
light
operation on
indicator light
7 6
Fig.1

Control pads

When you push the button to change operation modes, the unit
will make a beep sound to indicate that it is changing modes.
Power Pad
1
Press to turn the dehumidifier on and off.
NOTE: When the compressor startups or stops running, the
unit may make a loud voice, it is normal.
Mode Pad
2
Press to select the desired operation mode from
Dehumidifying,Dryer,Continuous dehumidifying and Smart
dehumidifying.
NOTE: Dryer and Smart dehumidifying modes are optional.
/ : Up/Down Pads
3 4
• Humidity Set Control Pads
The humidity level can be set within a range of 35%RH
(Relative Humidity) to 85%RH (Relative Humidity) in 5%
increments.
For drier air, press the
value (%).
Fan speed
indicator light
8
5 4
pad and set to a lower percent
Dryer
operation on
Bucket full
indicator light
indicator light
3
For damper air, press the
value (%).
• TIMER Set Control Pads
Use the Up/Down pads to set the Auto start and Auto stop
time from 0.0 to 24.
Fan Pad
5
Control the fan speed. Press to select fan speed in three
steps-low, med and high. The fan speed indicator light
illuminates under different fan speed settings. But when
select high fan speed, both the low and med fan speed lights
illuminate.
Timer Pad
6
Press to initiate the Auto start and Auto stop feature, in
conjuction with the
Wireless Pad(optional)
7
Press this pad for 3 seconds to initiate the Wireless
connection mode. The LED DISPLAY shows 'AP' (at this
time the unit shuts off all other functions) to indicate you can
set Wireless connection. If connection(router) is successful
12
Smart dehumidifying
Continuous
operation on indicator
operation on
light I
indicator light
2
pad and set a higher percent
and pads.
Unit operation
on indicator
light
1