Table of Contents
Advertisement
Available languages
Available languages
User manual
7.- CONTROLLING THE DEVICE
This
version
of
the
TDT+
configuration and control from a PC, both
locally and via remote control.
a.- Local control
The
user
must
have
the
Management" program version 2.1.0 or
upper and a special cable (provided with
this program) that connects a PC serial port
to the "PRGM" connector of the TDT+.
Using the program, the user can configure
and read all of the parameters, as well as
check that the device is working properly.
Below is a configuration screen of the TDT+.
it is possible to see that the configurable
parameters are the same as those that can
be configured using the remote control.
b.- Remote control
permits
As
well
as
mentioned, it is necessary to have a
Headend Control module (ref. 5051 or 5052)
and the corresponding modem connected
to the telephone line. Once communication
"Headend
has been established with the headend
control, you will be able to access all the
controllable devices that have been installed
in the headend.
In this case, it is essential that every element
is programmed using a different device
address (address RS485) between 1 and
254.
the
program
previously
18
TDT +
Advertisement
Table of Contents
