Switching On - Smeg PLA8743X Instruction Manual

EN
Only run the soak program with half loads.
To run programs 6, 7, 8, 9 (see tab. 2-03b), select the required standard pro-
gram (see programs 2, 3, 4, 5 in tab. 2-03a) and then press the "soak" button
(program 1 in tab. 2-03a).
The half-load option (ref. 3 fi g. 2-03) is available for all programs, except the
soak program.
After using the above tables to choose the most suitable washing cycle, pro-
gram the appliance.
2.2.1

Switching on

Press the on/off button (ref. 1 fi g. 2-03) to start the dishwasher. The relative
indicator light (ref. 6 fi g. 2-03) shines. Approximately 3 seconds later, the dis-
play (ref. 8 fi g. 2-03) will light up, showing information that will depend upon
the state of the dishwasher.
10
Before starting a washing program, make sure that:
• The water supply tap is open.
• There is regenerating salt in the water softener tank (to add
salt, see the instructions in the general manual).
• The correct amount of detergent has been added to the dis-
penser (to add detergent, see the instructions in the general
manual).
• The spray arms are able to rotate freely and without obstruc-
tion.
• The racks have been correctly loaded (see the instructions in
the general manual).
• The dishwasher door is securely closed.
USER INSTRUCTIONS
Rev 0.0