Setup Mode; Warning Factory Default Settings - Defi -Link Advance Operation Manual

The peak and warning LEDs in the gauge are lighted up.
4. If the
R
the
M
1000rpm, 2000rpm and 3000rpm indicate Position 1, Position2 and posi-
tion3 respectively.
5. Return the slide switch to
7 -6. Setup mode (slide switch position :
By setting warning values, the warning LEDs on the gauges light on when the
gauges reach or exceed the values. In case of oil pressure and fuel pressure,
when the gauge reaches or falls below the value set for warning, the warning
LED lights on. If ZDs are installed, warning setting is displayed on ZD display.
Warning values for gauges and ZDs are set at the same time.
In addition, the illumination color of CR/RS gauges can be selected from 2
colors in this mode. Illumination color of BF/A1 and ZD can not be changed.

Warning factory default settings

■
Gauge
Turbo3.0
Turbo1.2/2.0
In-Mani Press
Tachometer
Oil Press
Fuel Press
Oil Temp
Water Temp
Exhaust Temp
Depending on vehicle type and/or condition, vehicle may be damaged
even if the value is under the warning factory default setting value (over the
warning factory default setting value in case of oil pressure and fuel pres-
sure). Be sure to consult store professional to set warning values.
button is pressed, the position changes into 1 → 2 → 3. If
button is pressed, the position changes into 3 → 2 → 1.
U
default setting Unit Minimum Maximum Lighting condition
166.7
100
10
7000
120
150
125
105
850
or
M
L
Setting range
kPa -100
kPa -100
kPa -100
rpm 300
kPa 0
kPa 0
℃ 0
℃ 0
℃ 0
67
.
)
300
set value and above
200 set value and above
300 set value and above
11000 set value and above
1000 set value and below
600 set value and below
150
set value and above
150
set value and above
1100 set value and above