Set The Warning Value - Defi -Link Advance Operation Manual

7 -6-1. Set the warning value

1. Set the slide switch to
2. If the L
3. Select the gauge by pressing
CR/RS
gauges
BF/A1
gauges
ZD
In case that CR/RS gauges and ZDs are installed together and the dimmer
setting is AUTO, the illumination of CR/RS gauges turned ON/OFF automati-
cally regardless ON/OFF of the illumination switch of vehicle. If the setting
is done in bright light, the illumination of CR/RS gauges may be unlighted.
Please place a hand over the dim sensor of ZD or move vehicle to a dark
place.
The only selected gauges will be displayed in the following order.
Turbo・In-Mani Press→Tachometer→Oil Press
↑ ↓
Exhaust temp←Water Temp←Oil Temp←Fuel Press
4. When the
M
and when the
higher for the selected gauge. If each button is pressed long, the setting
value changes quickly.
If turbo(2.0 or 1.2) and intake manifold gauge are installed together, the set-
ting value of turbo(2.0 or 1.2) becomes the setting value of intake manifold.
You cannot set the value separately for each gauge. When both turbo2.0
and turbo1.2 are connected, turbo2.0 has a priority over turbo1.2.
Do not connect more than one gauge of the same variety.
L
button is pressed, the gauge shifts to Setup mode.
Selected
Warning LED: blinking
Illumination: bright
(while vehicle illumination is ON）
Warning LED: blinking
Illumination: bright
Highlighted
button is pressed, the warning value becomes lower,
button is pressed, the warning value becomes
R
L button.
(while vehicle illumination is ON）
68
Not selected
Warning LED: unlighted
Illumination: dark
Warning LED: unlighted
Illumination: dark
Not highlighted