Table of Contents
Advertisement
Setup Procedures
The items in this section provide the information necessary
to fully assemble, test, and prepare the unit, that these
instructions were included with, for delivery to your customer.
The Quick Setup List provided on page 2 of this booklet
to help you identify and check that the items have been
performed.
Uncrating
1. Locate the hydraulic actuators (A, Figure 1) on the side of
the unit's transmissions. There is one hydraulic actuator
on each transmission. The hydraulic actuator opens and
closes the transmission bypass valves.
1
2. To open the transmission bypass valves rotate
the hydraulic actuator clockwise to the "bypass"
position" (marked "bypass" on the transmission) (B).
3. Push the parking brake lever down and forward to release
the parking brake.
4. Be sure there are no nails or sharp objects on the bottom
skid to puncture the zero-turn rider's tires. Roll the zero-
turn rider forward off the bottom skid.
5. After moving the zero-turn rider, close the bypass valves
by rotating the hydraulic actuator counter-clockwise to
the "run" position (marked "run" on the transmission) (C).
Note: Both hydraulic actuators must be in the same position.
Operating the Seat Latch
Some models are equipped with a seat latch that secures the
seat plate in place. The seat latch is located by the left rear
corner of the seat plate.
1. To raise the seat plate, release the latch by moving the
seat latch (A, Figure 2) towards the front of the unit and
then raise the seat plate.
2
2. The seat latch is spring loaded. When the seat plate is
lowered back into place the seat latch will lock the seat
plate into place.
Connect the Battery Cables
WARNING
Battery acid can cause severe burns. Wear protective
gear when handling the battery.
Open flames and sparks can cause battery to explode.
BATTERY SAFETY RULES:
• Battery acid causes severe burns. Avoid contact with
skin.
• Wear eye protection when handling the battery.
• To avoid an explosion, keep flames and sparks away
from the battery, especially while charging.
• When installing the battery cables, connect the
positive (+) cable first and negative (-) cable last.
If not done in this order, the positive terminal can be
shorted to the frame by a tool.
1. Connect the red positive battery cable (A, Figure 3) to the
positive battery post.
3
Advertisement
Table of Contents
