Table of Contents
Advertisement
adjustment bolt(s) (A, Figure 41). Only adjust the speed of the
wheel that is traveling faster.
41
To Reduce the Speed of the Faster Wheel
1. Loosen the securing nut (B).
2. Turn the top speed adjustment bolt counter-clockwise to
reduce the speed.
3. Retighten the securing nut when adjustment is complete.
WARNING
DO NOT adjust the tractor for a faster overall speed
forward or reverse than it was designed for.
Cutting Height Adjustment
The cutting height adjustment pin (A, Figure 42) controls
the mower's cutting height. The cutting height is adjustable
between 1-1/2" (3,8 cm) and 5" (12,7 cm) in 1/4" (0,64 cm)
increments.
Note: Make sure that the pin is inserted into the holes in both
upper and lower plates of the pin box (B).
42
To set the cutting height at 1-1/2" (3,37 cm):
18
1. While sitting in the operator's seat, press the deck lift
foot pedal (C) forward until it locks into the 5" (12,7 cm)
position.
2. Remove the cutting height adjustment pin from the hole
that it is installed in.
3. Press the deck lift foot pedal forward and then push the
lock lever (D) towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to
rest against the stationary pin (E) in the 1-1/2" (3,37 cm)
cutting height hole.
5. Place the cutting height adjustment pin in the storage
hole (F).
To set the cutting height in the range of 1-3/4" (4,40 cm)
and 4-3/4" (12,06 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in the desired
cutting height.
3. Press the deck lift pedal forward and then push the lock
lever towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to rest
against the cutting height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in any open
cutting height hole. The lift lock lever holds the mower
deck at 5" (12,7 cm) while cutting.
Neutral Adjustment
The neutral system for this mower consists of two neutral
linkage rods and a pivot that connects the ground speed
control lever to the transmission. The lower rod that connects
the transmission to the pivot is factory preset and should not
be changed for neutral adjustment purposes. The adjustment
is achieved by changing the length of the upper rod (A, Figure
43) that connects the ground speed control lever to the pivot.
ferrismowers.com
Advertisement
Table of Contents
