Briggs & Stratton IS3200ZKAV3561 Dealer Setup & Adjustment Instructions Manual page 9

Zero-turn rider 61"/72" mower deck

Table of Contents

7. Have an assistant use the deck lift pedal to raise or lower

the deck linkages as necessary while you install the 1/2

bolt (C) and 1/2 washer (D) through the middle hole (E)

of the mower deck connection points and the spacer and

secure with the hex nylock flange nut (F).

• The hardware used to secure the front of the mower

deck to the deck linkages is routed so that the

threads of the bolt face towards the center of the

mower deck.

• The hardware used to secure the rear of the mower

deck to the deck linkages is routed so that the

threads of the bolt face towards the outside of the

mower deck.

8. Remove the blocking from underneath the mower deck.

Install the Discharge Chute (72" Side

Discharge Export Models)

1. Install the discharge chute (A, Figure 19) onto the mower

deck (B) as shown in Figure 19 using the pivot rod (C).

2. Secure the discharge chute to the mower deck using two

(2) 5/16 washers (D) and nylon nuts (E). The mower deck

should never be run without the discharge chute installed

and positioned in the down position.

WARNING

Amputation and Thrown Object Hazard

To avoid injury from rotating blades, stay clear of deck edge

and keep others away. Do not mow without discharge chute

or entire grass catcher in place.

Install the Deck Belt (72" Export Models)

1. Lower the mower deck to it's lowest cutting position and

remove the mower deck guards and the floor pan of the

machine.

2. Install the long left hand belt (A, Figure 20) through the

PTO clutch pulley belt guide (B) onto the PTO clutch

pulley (C) and the center spindle pulley (D).

Table of Contents