Chapter 5. Checklists For Major Machine Component Management - icetro SSI-141TG User Manual

Chapter 5. Checklists for Major Machine Component Management

"We recommend that you keep the machine clean by washing it daily"
Keeping the machine clean
1. Clean and sterilize the machine thoroughly at a regular interval through complete
disassembly and brush washing.
2. Use very cleanly treated brushes only.
3. The cleaning brush is used to clean the mix inlet hole by extending it from the lower part
of the mix container uo to the rear of the freezer cylinder.
4. The cleaning brush is used to clean the rear side of the bearing behind the freezer
cylinder.
5. Use a reasonable amount of detergent fluid only. Read and follow the instructions on the
label carefully. Solution that is too strong damages parts and components, while solution
that is too week is unsuitable for washing and sterilization.
6. Keep the mix container at 40℉ (4.4℃)or lower.
Regular maintenance checkpoints
1. Check if the dasher has been damaged.
2. Check for any trace of wear on the bearing.(A worn bearing causes an excessive amount
of mix at the rear part of the drain water trap.)
3. Remove any oil and Mix the dregs from the bearing and the hexagonal drive socket with
a screwdriver and a towel.
4. Replace any worn, torn or loose O-ring or seal with a new one.
5. For grease application, follow the "assembly" procedure.
6. In the case of an air-cooled machine, check if any dust or nap has accumulated. A dirty
condenser lower efficiency and machine performance. Clean the condenser with a soft
cloth once a month. Do not clean between fins with a screwdriver or any other
sharp-ended metal.
Make sure to turn the power off before cleaning the condenser.
Warning
Long-term storage
If the machine is not in use for an extended period of time, preventive measures are
necessary to protect the ice cream machine. They are very important, especially if the
building has problems with freezing.
1. To prevent any electrical damage, pull out the power plug from the receptacle
2. Pack detachable components such as the mixer, the blade, the drive shaft and the
doors from the ice cream machine.
3. Protect the rubber parts and the gaskets by packing in desiccant paper
4. Thoroughly remove from all parts and components any dried mix or grease that may
attract mice and other pests.
5. By observing the above points sincerely, you can and store your ice cream machine
correctly.
17