Korg Minilogue XD Owner's Manual page 26

Real-Time recording
This feature allows you to record your keyboard performance on the minilogue xd and add over-
dubs (recording while adding performance data) in real time.
1.
Press the PLAY button in the SE-
QUENCER section while the sequenc-
er is stopped.
If a recording already exists, the se-
quence data will begin playing.
2.
Press the REC button.
Real-time recording will begin, and
the REC button will light.
3.
Play the keyboard.
The note(s) you play will be recorded.
4.
Press the REC button once more to stop the recording.
The REC button will go dark.
Press the REC button once more to start recording again.
When you hold down the REST button during real-time recording, the existing notes in
Tip:
the sequence will be deleted.
5.
Press the PLAY button to finish real-time recording.
The PLAY button will go dark.
Recording a motion sequence
Motion sequencing allows you to record the flipping of switches and the turning of knobs as part
of the sequence, and recreate those motions automatically during playback.
Up to four motion sequences can be recorded, which includes changes to the knobs and switches.
The knobs, switches for which you cannot record motions are as follows.
Note:
MASTER knob, TEMPO knob, OCTAVE switch (MASTER), MULTI ENGINE TYPE-USR,
DRIVE switch (FILTER), DEL/REV/MOD switch, SELECT setting of the OFF/ON/SELECT
switch.
1.
Press the PLAY button to play the sequencer, and then press the MOTION MODE button.
"MOTION VIEW" will appear in the display, and the motion sequence saved to the program
will show up as a visual graphic.
2.
Press the REC button.
Real-time recording will begin.
3.
Move the knobs and switches on the minilogue xd.
You can record up to four motion sequences for the knobs and switches.
If you exceed this limit, the message "Motion Full" will be shown in the display, and the
Note:
display will enter MOTION CLEAR in the SEQ EDIT mode. See steps 2 and afterwards in
"Deleting a motion sequence" (p.27) for details.
For motion sequences of knobs and switches you moved that are already recorded, the
Note:
data previously recorded will be overwritten.
26
1, 5 2, 4