Table of Contents
Advertisement
LMspiaymg signals
3-28
Triggering with an Externa! Signal
Trigger one- or two-channel displays with an externally applied signal using
the following procedure:
□
Step 1: Apply the external signal to the EXT INPUT connector using a
coaxial cable.
□
Step 2: Set the SOURCE to EXT
□
Step 3: Select the EXT COUPL mode: AC, DC, or DC ™ 10.
□
Step 4: Adjust the TRIGGER LEVEL for a stable display.
Triggering on TV Signals
You can trigger on either TV line or TV field signals.
Triggering on a TV Line Signal
H
Step 1: Push in the P-P AUTO/TV LINE trigger mode button.
□
Step 2: Apply the TV signal to a channel input and display the channel.
□
Step 3: Set the VOLTS/DIV switch to display 0.3 or more of composite
video signal.
P I Step 4: Set the SEC/DIV switch to 10 ps.
P I Step 5: Set the TRIGGER SLOPE switch either out (for positive-going
TV Signal sync pulses) or in (for negative-going TV signal sync pulses).
□
Step 6: Adjust the TRIGGER LEVEL stabilize the display (Figure 3-27).
= 0 . f i
0 0
a u i
' — 1
J M
If
in * * t
i m l
i f
0 . 5 U
Figure 3-27: Multi-burst Signal Triggered in TV Line
Triggering on TV Field
□
S tepl: Set the TRIGGER Mode to TV FIELD. (Press the P-P AUTO and
NORM mode buttons in at the same time.)
u
U
4T = 0
T R IG 0 =
8 .2Ej
6
x l
!
S R F T
'
A
r
4M»+
U 1
A
J___
L
j
I
p e
r k d e
U s
:
t
ie
.
s
| i
min
Iff!
In Detail
Advertisement
Table of Contents
