Cheek Pad Assembly; Adjusting The Roll Neck Stretch - Nolan N100-5 Safety And Instructions For Use

8

CHEEK PAD ASSEMBLY

8.1 Put the left cheek pad against the corresponding polystyrene inner cheek pad,
insert the chin strap into the passageway of the cheek pad padding and push it
near the three buttons on its back in order to fasten them to their seats (Fig.15).
8.2 Repeat these steps with the right cheek pad padding.
Warning: the buttons are not fastened until a click is heard. Check that the strap
comes out properly from the cheek pad padding.
8.3 Insert the chin strap band into the elastic loops on the roll neck (Fig.14).
WARNING
- If your helmet is equipped with the double D-Ring retention system, pull it
down as indicated in the attached double D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely fitted.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to dry
at room temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.
9

ADJUSTING THE ROLL NECK STRETCH

The roll neck stretch can be adjusted to adapt to the different sizes or riding positions
of the riders.
9.1 To increase the roll neck stretch press the button of the left strap clip and simulta-
neously pull the elastic strap towards the rear part of the helmet (Fig. 23). Follow
the same steps on the other side of the helmet.
9.2 To decrease the roll neck stretch press the button of the left strap clip button and
simultaneously push the rear part of the roll neck to loosen the stretch of the elas-
tic strap (Fig. 24). Follow the same steps on the other side of the helmet.
9.3 Wear and fasten the helmet (see instructions above) and make sure that the roll
neck stretch in the riding position is satisfactory.
WARNING
After assembling or disassembling the roll neck and/or adjusting the stretch, wear
and fasten the helmet to check the correct adjustment of the chin strap (see at-
tached label), the correct positioning of the helmet on the head in the riding posi-
tion and the VPS functionality in all positioning notches.
INSTRUCTIONS FOR USE
N100-5
23