Pinlock Inner Visor Assembly; Checking And Adjusting The Pinlock Inner Visor Stretch - Nolan N100-5 Safety And Instructions For Use

N100-5
(Available as standard or accessory/spare part)
1 PINLOCK INNER VISOR ASSEMBLY
®
1.1 Disassemble the visor (see instructions above).
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.8).
1.3 Place the PINLOCK
The silicone-sealed profile of the PINLOCK
the inner surface of the visor.
1.4 Insert one side of the PINLOCK
in position (Fig.9).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.10).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor on the helmet (see instructions above).
2 CHECKING AND ADJUSTING THE PINLOCK
Check the correct PINLOCK
and making sure that they do not move.
If the PINLOCK inner visor is not tightly fixed to the visor, simultaneously move both
®
external adjustment levers upwards to increase the stretch (Fig.8). This operation must
be carried out gradually. The maximum stretch is achieved when the pin adjustment
external levers are turned outwards.
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions (low tem-
peratures, high humidity, sudden changes in temperature or heavy rain) or intense
and prolonged use may affect the performance of the PINLOCK
cause fogging or formation of condensation. In such cases, to restore the sys-
tem efficiency after using the helmet, remove the PINLOCK
helmet visor and let it dry with dry and warm air. The same procedure must be
applied to the helmet, in order to dry out humidity in case it has formed up as a
consequence of the conditions described above.
18
INSTRUCTIONS FOR USE
inner visor on the visor.
®
inner visor onto one of the visor pins and hold it
®
inner visor assembly by opening and closing the visor
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
inner visor must be in contact with
®
inner visor to the other
®
inner visor and check that the
®
INNER VISOR STRETCH
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor from the
®
inner visor and
®