Connection Status Check - Omron G9SP-N20S Network Connection Manual

7.4. Connection Status Check

Execute the project file that was transferred and confirm that serial communications are
performed normally.
Sufficiently confirm safety before you change the values of variables on a Watch
Tab Page when the Sysmac Studio is online with the CPU Unit. Incorrect
operation may cause the devices that are connected to Output Units to operate
regardless of the operating mode of the Controller.
Precautions for Correct Use
Please confirm that the serial cable is connected before proceeding to the following steps.
If it is not connected, turn OFF the power of the devices, and then connect the serial cable.
7.4.1. Executing the Ladder Program and Checking the Receive Data
Execute the ladder program and confirm that the correct data are written to the variables of
the Controller.
1
Select Mode - RUN Mode from the
Controller Menu.
A confirmation dialog box is
displayed. Click the Yes Button.
2
RUN mode is displayed on the
Controller Status Pane.
3
Select Watch Tab Page from the
View Menu.
7. Connection Procedure
22