Network Card - GE ApexPro Service Manual

Network card

2001989-203C
1. Complete the preparation procedures.
7-3.
2. Disconnect the network cable plug from the connector at the back of the network
card.
3. Remove the chassis cover.
4. Remove the 3 screws securing the back of the CPU module to the chassis.
5. Remove the 2 screws securing the front of the CPU module to the chassis.
6. Carefully move the CPU module far enough to allow card removal.
7. Using a phillips screwdriver, remove the screw securing the network card in the
slot.
8. Remove the network card from the slot.
9. Reverse the steps in this procedure to install the network card.
ApexPro™ Telemetry
Parts lists, drawings and replacement
See Field replacement preparation on page
See Chassis cover on page 7-6.
046A
048A
163A
164A
7-7