Update Via File Selection; Tftp Update - Hirschmann RS20 Reference Manual

Basic Settings

1.3.2 Update via file selection

For an update via a file selection window, the device software must be on a
data carrier that you can access via your PC.
In the file selection frame, click on "...".
In the file selection window, select the device software (device.bin) and
click on "Open".
Click on "Update" to transfer the software to the device.
The end of the update is indicated by one of the following messages:
Update completed successfully.
Update failed. Reason: incorrect file.
Update failed. Reason: error when saving.
File not found (reason: file name not found or does not exist).
Connection error (reason: path without file name).
After successfully loading it, you activate the new software:
Select the Basic Settings:Restart dialog and perform a cold start.
In a cold start, the device reloads the software from the non-volatile mem-
ory, restarts, and performs a self-test.
In your browser, click on "Reload" so that you can access the device again
after it is booted.

1.3.3 tftp update

For a tftp update you need a tftp server on which the software to be loaded
is stored.
The URL identifies the path to the software stored on the tftp server. The URL
is in the format tftp://IP address of the tftp server/path name/file name (e.g.
tftp://192.168.1.100/product/product.bin).
Click "tftp Update" to load the software from the tftp server to the device.
To start the new software after loading, cold start the device
„Restart").
24
1.3 Software
(see on page 35
RM Web L3P+
Release 5.0 04/09