Network Setup - Digitus IP Network Camera None User Manual

`
Detailed explanations are presented in the next chapter.
5.3.1 Event
Event settings, including:
- Motion Detection (set 1)
- Motion Detection (set 2)
Individual or both set signal input triggers can be seleced.
How to Use Event Settings
Step 1. Activate Event for either set (MD will automatically display the trigger sensitivity)
Step 2. After you are finished, click on
Step 3. Click on
Note: After engaging either type of event, " Save in PC" will automatically turn on.
5.3.2 Trigger
Event trigger image transfer settings, including:
- Save in PC The image file is saved in your computer.
- Save in Flash Card The image file is saved in the SD card.
- Mail Image Send captured event trigger image file by e-mail.
- FTP Image
Shutter Timer Change shutter time for event trigger image capture. two (2)
-
seconds is the default setting.
5.4 N S
ETWORK ETUP
Network Setup can be used to change the network connection settings of the IP CAM.
The default value for IP assignment is " static" . These settings also include:
- IP Assignment Static, DHCP, or PPPoE
- PPPoE settings (PPPoE is the most common type of Broadband Internet connection,
where your ISP assigns a different IP address to your connection each time you log on)
- Http Server port settings
- Set the port of UDP Server and also Audio Port
- DNS settings
MAC Address Displays the Mac address of the IP CAM
IP CAM USER' S GUIDE
to use factory default settings (sets all to off).
Default
Send captured event trigger image file by FTP.
, otherwise;
Submit
PAGE 37/57
IP CAM User' s Guide
P a n / T i l t I P S u r v e i l l a n
P a n / T i l t I P S u r v e i l l a n
c e C a m e r a
c e C a m e r a
Rev. PV1.0