Connect The Adsl Line; Phone Line Configuration - SMC Networks Barricade SMC7404WBRA EU User Manual

Connect the ADSL Line

Run standard telephone cable from the wall jack providing ADSL service
to the WAN port on your Barricade. When inserting an ADSL RJ-11 plug,
be sure the tab on the plug clicks into position to ensure that it is properly
seated. If you are using splitterless ADSL service, be sure you add low-pass
filters between the ADSL wall jack and your telephones. (These filters pass
voice signals through but filter data signals out.)

Phone Line Configuration

Installing a Full-rate Connection
If you are using a full-rate (G.dmt) connection, your service provider will
attach the outside ADSL line to a data/voice splitter. In this case you can
connect your phones and computer directly to the splitter as shown below:
Plain Old
Telephone
System (POTS)
Residential
Connection
Point (NID)
Figure 2-1. Installing with a Splitter
Voice
Splitter
Data
ADSL Router
or
Ethernet
hub or switch
C S
ONNECT THE YSTEM
2-5