Troy-Bilt WindConnect II User Manual page 48

Appendix B
Regulatory
European Union (EU)
Information
TROY hereby declares that the Bluetooth™ wireless technology built into the WindConnect II Bluetooth printer
adapter, is in compliance with the essential requirements and other relevant provisions of European Directive
1999/5/EC. The internal Bluetooth function is a Bluetooth power class 1 intended radio device using the 2.4
GHz frequency band (2.400GHz – 2.4835GHz). It is intended for wireless communication with other Bluetooth-
enabled devices using the Bluetooth Generic Access, Service Discovery Application, Serial Port and Object
Push Networking profiles. The internal Bluetooth wireless technology complies with all applicable regulations in
the following countries: Austria, Belgium, Denmark, Finland, Greece, Germany, Iceland, Ireland, Luxembourg,
Norway, Portugal, Spain, Sweden, Switzerland, the Netherlands and the United Kingdom.
The use of Bluetooth wireless technology in other countries than those listed above may be restricted: before
using Bluetooth products, please confirm with the frequency management authority in the country where you
plan to use it. In some situations or environments, the use of Bluetooth wireless technology might be restricted
by the proprietor of the building or responsible representatives of the organization, for example onboard
airplanes, in hospitals or in any other environment where the risk of interference with other devices or services is
perceived or identified as harmful.
If you are uncertain of the policy that applies to the use in a specific organization or environment, you are
encouraged to ask for authorization to use Bluetooth wireless technology prior to switching it on. Consult your
physician or the manufacturer of personal medical devices (pacemakers, hearing aids, etc.) regarding any
restrictions on the use of Bluetooth wireless technology.
United States of America and Canada
Tested to Comply With FCC Standards FOR HOME OR OFFICE USE. See FCC 47CFR, Part 15.19(b)(2).
This device complies with part 15 of the FCC rules and with RSS-210 / RSS-139 of the Industry Canada.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
The radiated output power of WindConnect II wireless printer adapter is far below the FCC radio frequency
exposure limits. Nevertheless, the WindConnect II shall be used in such a manner that the potential for human
contact during normal operation is minimized. A minimum separation of 20 cm (8 inches) must be maintained
between the antenna and the person for this device to satisfy the RF exposure requirements of the FCC. Note
that any changes or modifications to this equipment not expressly approved by the manufacturer may void the
FCC authorization to operate this equipment.
Canada (IC notice)
To prevent radio interference to the licensed service, this device is intended to be operated indoors and away
from windows to provide maximum shielding. Equipment that is installed outdoors is subject to licensing.
WindConnect II Printer Adapter with Bluetooth Technolgy User's Guide -- Document #40xxx-110 Rev. X3
Safety and Regulatory Notices
B-3