Verifying Successful Installation; Verifying The Connection To The Printer - Troy-Bilt WindConnect II User Manual

Section 2
Verifying
After the WindConnect II is attached to the printer and powered ON, it will perform a brief startup sequence:
Successful
Installation
NOTE: If the bi-colored LED does not illuminate green continuously after the device has finished its startup
sequence, then there may be an error. Refer to Chapter 5 – Troubleshooting in this user's guide for help.
Verifying the
To verify the connection, make sure that both the WindConnect II and the printer are powered on and ready. If
the printer adapter has detected the printer and successfully set up communication with it, the green LED will
Connection
illuminate continuously. If the bi-colored LED remains amber, refer to Chapter 5 – Troubleshooting in this
to the Printer
user's guide.
Then print a test page by momentarily pressing the test button on the WindConnect II for approximately one
second. If the test page prints successfully, then the WindConnect II is ready to print, providing that the client
computer and sending device are ready to print.
If the test page does not print, first check to make sure the WindConnect II is securely connected to the printer.
Also, make sure that the printer is operating properly and has a sufficient supply of paper and toner or ink.
Switch the WindConnect II off and then on again, and then try printing the self-test page again by pressing the
test button for approximately one second. If you cannot print a test page, refer to Chapter 5 – Troubleshooting
in this user's guide.
WindConnect II Printer Adapter with Bluetooth Technology User's Guide -- Document #40xxx-110 Rev. X3
1. The bi-colored LED (amber) and the blue LED will blink three times simultaneously.
2. The bi-colored LED will alternately blink amber and green twice. The blue LED will not illuminate.
3. The bi-colored LED will illuminate green continuously, and the blue LED will blink continuously, indicating
a ready state. After connectivity has been established, the blue LED will illuminate continuously.
Hardware Installation Procedures
2-4