Section 4 - Configuring Your Printer Adapter; Overview; Summary Of Configuration Steps; Installing The Troy Configuration Utility - Troy-Bilt WindConnect II User Manual

Section 4

Overview

The WindConnect II is preconfigured to allow you to print right out of the box; however, you may optionally
reconfigure the device at any time using the provided TROY Configuration Utility and the instructions provided in
this chapter. The Configuration Utility allows you to change the device name, enable/disable the discovery
feature, select security features, and update the device's firmware.
Summary of
The following basic steps are required to change the configuration of your WindConnect II. A sending device
must be installed on your PC in order to access the WindConnect II.
Configuration
Steps
Installing the
1. Load the TROY WindConnect II Installation CD into the CD-ROM drive of your computer. The CD should
Configuration
Utility
2. From the CD menu, click on Install Configuration Utility to begin the installation process. When the
WindConnect II Printer Adapter with Bluetooth Technology User's Guide -- Document #40xxx-110 Rev. X3
Connect to the WindConnect II from your PC. You must use the Serial Port Profile (SPP), which will
require that you set up a COM port.
Install the TROY Configuration Utility on your PC.
Place the WindConnect II into configuration mode by pressing the test button for five seconds.
Configure the WindConnect II using the TROY Configuration Utility
start automatically and display a menu.
NOTE: If the CD fails to start automatically, click on the Windows Start button, select Run, type D:\setup.exe,
and then click on OK to begin the installation process.
Welcome window appears, click on Next to continue the installation process. Follow the prompts to install
the software.
NOTE: To exit the installation process at any time before the installation is complete, click on Cancel to stop
the installation process.
Configuring Your Printer Adapter
4-1