Test Button Sequences - Troy-Bilt WindConnect II User Manual

Section 5
Test Button
Sequences
Print a Test/Configuration
Page
Perform a Cold Reset
(restores factory defaults)
Enter Configuration/
Firmware Upgrade Mode
WindConnect II Printer Adapter with Bluetooth Technology User's Guide -- Document #40xxx-110 Rev. X3
Command
Press the test button for approximately one second (do not press it for more than three
seconds). A test page will print, and the bi-colored LED will blink green during printing.
Press and hold the test button while applying power to the device, and then release the
test button and allow the unit to initialize (approximately four seconds). All non-volatile
parameters will be reset to their factory default values.
Press and hold the test button for at least five seconds until the bi-colored LED cycles
between amber and green to indicate that it has entered the configuration mode. A
firmware upgrade or configuration can now be performed using the provided TROY
Configuration Utility.
After the print adapter is reprogrammed by a firmware upgrade, it will automatically
reboot and then indicate a ready state (solid green LED).
If the firmware update process fails, the print adapter will automatically reboot and then
return to the configuration mode if the flash memory was programmed incorrectly.
Troubleshooting
Sequence
5-8