Appendix B Safety And Regulatory Notices - Troy-Bilt WindConnect II User Manual

Appendix B
This equipment has been tested and found to comply within the limits for a Class B digital device pursuant to
FCC
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
Compliance
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
Statement for
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
United States radio or television reception. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio and television reception, which can be determined
Users
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Warning
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by the FCC for
this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with
this device. If this equipment has more than one interface connector, do not leave cables connected to unused
interfaces.
authority to operate the equipment.
For European
This product is in conformity with the protection requirements of EU Council Directive 89/336/EEC on the
approximation of the laws of the Member States relating to electromagnetic compatibility. TROY cannot be
Users
responsible for any failure to satisfy the protection requirements resulting from a non-recommended modification
of the product.
This product has been tested and found to comply with the limits for Class B Information Technology Equipment
according to CISPR 22/European Standard EN55022. The limits for Class B equipment were derived for typical
residential environments to provide reasonable protection against interference with licensed communications
devices.
WindConnect II Printer Adapter with Bluetooth Technolgy User's Guide -- Document #40xxx-110 Rev. X3
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit other than the circuit bused by the receiver
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the manufacturer could void the user's
Safety and Regulatory Notices
B-1