Troy-Bilt WindConnect II User Manual page 10

Section 2
Installing the
1. Depending on your model of printer adapter, connect the WindConnect II directly to either the USB or IEEE
Hardware
onto the USB
or Parallel
Port
2. Plug the power supply module into a suitable AC wall outlet, and then plug the power supply cable into the
Installing the WindConnect II onto the parallel port
WindConnect II Printer Adapter with Bluetooth Technology User's Guide -- Document #40xxx-110 Rev. X3
1284-compliant parallel port of the printer as shown below.
•
If you connect the WindConnect II to the parallel port, be sure to secure the metal locking clasps
located on each side of the parallel connector to prevent the device from being accidently
disconnected.
•
If you connect the WindConnect II to the USB port of the printer, use the supplied Velcro tabs to
attach the printer adapter to the printer or other convenient surface.
WindConnect II as shown. When power is applied to the WindConnect II, the blue and green LEDs will blink
three times simultaneously as it performs self-checking diagnostics. Refer to Chapter 5 – Troubleshooting
in this user's guide for detailed LED status light descriptions.
NOTE: Some printers supply 5 volts on pin 18 of the parallel port, which can be used to power the printer
adapter without the need for an external power supply. Refer to the owner's manual that came with your
printer. If you are using the USB connection, the external power supply is required.
Hardware Installation Procedures
Installing the WindConnect II using the USB connection
2-3