Eaton/Dana Axle Lubrication - Peterbilt 348 2017 Operator's Manual

LUBRICANT SPECIFICATIONS
Application
On Highway
City Delivery
Off Highway
•
Change the lubricant filter every
120,000 miles (192,000 km). Top
off the lubricant level with a similar
5
lubricant.
5-50
Type Of Lubricant
Synthetic
Synthetic with Pump and Filter
Mineral Base
Synthetic
Synthetic with Pump and Filter
Mineral Base
Synthetic
Synthetic with Pump and Filter
Mineral Base

Eaton/Dana Axle Lubrication

•
The original mineral-based
lubricant must be drained within
3000-5000 miles (4800-8000
km) on all Eaton axles. This
initial change is very important
because it flushes out break-in
contaminants that might otherwise
cause premature wear.
•
No initial drain is required on
Eaton axles that are factory filled
Y53-6060-1C1
Mileage Interval
240,000 mi. (384,000 km)
500,000 mi. (800,000 km)
120,000 mi. (192,000 km)
120,000 mi. (192,000 km)
240,000 mi. (384,000 km)
120,000 mi. (192,000 km)
120,000 mi. (192,000 km)
120,000 mi. (192,000 km)
120,000 mi. (192,000 km)
with an Eaton-approved synthetic
lubricant.
•
Mineral-based lubes must be
drained within the first 5000 miles
(8000 km) if converting to an
Eaton-approved synthetic lube.
•
Change the lubricant within the
first 5000 miles (8000 km) of
operation after a carrier head
replacement, regardless of the
lubricant type.
(03/17)