Light Bulbs - Peterbilt 348 2017 Operator's Manual

ELECTRICAL
WARNING!
Do not use the Spare Battery A &
B circuits or other circuits that are
controlled by the LVD to power elec-
tronic engine controls, ABS circuits,
or safety/work-related lighting. Be-
fore adding any device to the vehi-
cle's electrical system, consult your
nearest authorized dealer or read
the contents of TMC RP-136. Fail-
ure to do so may cause equipment
damage or lead to personal injury.
NOTE
The determination of what cir-
5
cuits/loads that were connected to
the LVD was based upon the rec-
ommendation from Technology and
Maintenance Council (TMC) of the
American Trucking Association. To
review the recommended practice,
see TMC RP-136.
5-86

Light Bulbs

Headlight Replacement
Replacing a headlight bulb is
accomplished by accessing the rear
of the headlight via a access panel in
the front fender. Open the hood to get
access to this panel.
Once the panel is open, the headlight
bulb socket may be removed to replace
the bulb.
WARNING!
Optional HID headlights have high
voltage circuits and should only be
serviced by a trained technician. At-
tempting to service the HID ballast
without proper training may result in
severe electrical shock which could
lead to death or personal injury.
Y53-6060-1C1
Access door
(03/17)