Alarm.Com ADC-IS-100-LP Installation & User Manual page 3

use the washer and small screw to
secure the mounting arm to the sensor
back.
5) Slide the sensor back and mounting arm
assembly onto the mounting bracket.
Adjust the horizontal positioning of the
sensor to point towards the desired
coverage area. To adjust positioning, lift
the mounting arm at least 1/3 of the way
off the bracket and rotate the arm.
6) See "Programming- Enrolling Sensors"
instructions for enrolling the sensor into
the panel. After enrolled, slide the
sensor onto the mounted sensor back.
7) Perform sensor testing.
8) Secure the mounting arm location by
sliding the lock pin into the hole. Use
the remaining small screw to secure the
lock pin by screwing it up through the
bottom of the hole in the mounting
bracket.
Programming- Enrolling Sensor
The ADC-IS-100-LP and ADC-IS-100-SL is enrolled
in the control panel via the Interactive Services
menu, which is visible when the Alarm.com
Image Sensor enabled GSM Module is used.
Before completing image sensor enrollment, the
control panel should be communicating with
Alarm.com. For questions on modules and panel
compatibility, refer to the Support Tools section
of the Alarm.com Dealer Site.
To enroll the sensor in the Simon XT 1.3:
1) Remove batteries from the sensor.
2) On the panel, scroll until the screen
displays "System Programming", press
OK.
3) Enter the installer code (default 4-3-2-1)
and press OK.
4) Scroll to "Interactive Services", press OK.
Installation Instructions
5) Scroll to "Image Sensor Setup", press OK.
6) Scroll to "Image Sensor Learn Mode",
press OK.
7) Insert the batteries into the sensor.
8) Wait (approximately 10 seconds) for the
control panel screen to display "Camera
[x] Added as Sensor [y]".
9) The sensor is now learned into the panel.
The sensors are enrolled in group 17 by
default. To change the sensor group, use
the Sensors menu in System
Programming.
ADC-IS-100-LP
3