Advertisement
11. The delivered screen has end positions set in accordance with the order. If the surface of the screen
scrolls too low or not enough, correct the bottom end position using the included wrench. Before
adjustment, check in the warranty card with what type of engine is your screen equipped with.
NOTE! Adjustments to the end positions can only be made by a qualified person. All adjustments are
made at your own risk. In the event of an inaccurate adjustment, the screen may get damaged, which is
not covered by the terms of the warranty.
Fig.10
12. After final verification of the entire installation, place the side panels on magnets stuck to the panels
(Fig. 11). In screens with side tension, unfold the surface completely. If necessary, use the allen key to
adjust the tension with the bolts on both sides of the bottom bar.
Fig.11
Yellow end stop
w
w
w .
k
a u
Access to the
end stop
b
e
r .
e
-10-
White end stop
u
Advertisement
