Advertisement
Quick Links
Advertisement
Related Manuals for Kauber FRAME Series
Summary of Contents for Kauber FRAME Series
- Page 1 PROJECTION SCREEN INSTALLATION MANUAL Frame screen FRAME...
- Page 2 The FRAME series includes projection screens with a perfectly taut projection surface stretched on a stylish aluminum construction. This series is dedicated to demanding users and is specially designed for home theater and lecture halls. CAUTION!!! INSTALLATION AND OPERATIONAL NOTES 1.
-
Page 3: Screen Installation
SCREEN INSTALLATION 1. Put all the frame elements on a clean and level surface. Slide the angle iron into the profile of the screen frame with the smooth side up as shown in Figure 2 (the protruding parts of the thread must be at the bottom of the angle iron). - Page 4 3. Adjust the screen profiles to obtain a right angle and tighten the "A" screws (Fig. 5). If the frame profiles do not form a single plane, use the "B" screws (Fig. 4) to calibrate the profile by tightening one of the screws to get as equal plane as possible, as shown in Figure 6.
- Page 5 5. Gently insert the attached steel bars (Fig. 9) into the welded surface pockets. Then, pull and fix the surface to the frame with plates (Fig. 10 to Fig. 15). Fig.9 Fig.10 Fig.11 Fig.12 Fig.13 Fig.14...
- Page 6 Fig.15 6. Attach the magnet (Fig. 16) to the lower frame profile (Fig. 17) at a distance ofup to 20 cm from the edge of the frame. Fig. 16 Fig.17...
- Page 7 7. Attach the mounting brackets (Fig. 18) to the wall, keeping in mind that the hanging frame will be about 3mm above the top of the bracket (about 66 mm from the bottom edge of the bracket). Mounted brackets must be within 30 cm from the ends of the screen frame.
-
Page 8: Technical Data
TECHNICAL DATA Dimensions of the housing: Width of the surface Height of the surface Thank you for choosing the KAUBER screen You are more than welcome to buy other KAUBER products...