Harmar Mobility AL600 Installation And Owner's Manual page 26

Installation - AL690
6. Plug Hand
Controller into lift.
[Figure 26-1]
Figure 26-1
7. Connect to vehicle
harness. [Figure 26-2]
BLACK
FROM LIFT
RED
Figure 26-2
8. Press the DOWN button until
the lift's tower has moved out of
the vehicle. [Figure 26-3]
The platform components may be re-
assembled to match the opening of the
vehicle's side door. [Figure 26-4]
26
SECTION 2 : INSTALLER
From vehicle harness
( installed on page 12)
BLACK
FROM VEHICLE HARNESS
( FROM BATTERY )
RED
Figure 26-3
W ID T H O F
V E H IC L E
O P E N IN G
Figure 26-4
| www.harmar.com | 800-833-0478
9. Attach platform by placing platform's upright
pins into u-shaped bracket on tower. [Figure 26-5]
10. Install ½-13 x 1-3/4"
Hex head Bolts and ½"
flat washers into threaded
Figure 26-5
holes as shown. [Figure 26-6]
Test full motion of lift into
and out of the vehicle. Be
sure lift is level and that no
obstructions interfere with
the travel of the platform.
Tighten ALL fasteners
from ALL steps.
Figure 26-6