Table of Contents
Advertisement
5.
In the Scan for LDM Units window:
•
Select the COM port from the drop-down list—for example, COM1.
•
Make sure the baud rate is 115200.
•
Click the Start Scan button to check for a connection to the unit.
6. If the Liebert LDMF unit is detected, a confirmation window appears. Click Yes to continue and proceed to
Step 7.
If the Liebert LDMF unit is NOT detected, an error message appears. Click OK to return to the Upgrade
Firmware window. Check to verify the following, then repeat Step 5:
•
The correct COM Port is selected and the baud rate is 115200.
•
A serial cable is properly connected to the unit (see 5.2.1 - LDMF Setup Port Connection).
•
The Liebert LDMF unit is powered ON.
| Liebert® LDMF™ Distribution Monitoring User Manual |
Vertiv
™
Start Scan
Button
40
Hide quick links:
Advertisement
Table of Contents
