Advertisement
Available languages
Available languages
HANGING THE FAN (CONTINUED)
5.
B
C
E
Slip the coupling cover (E), canopy cover ring (D)
and canopy (C) onto the downrod (B).
Carefully reinstall the hanger ball onto the downrod (B),
being sure that the cross pin is in the correct position,
the set screw is tightened and wires are not twisted.
WARNING: Install canopy cover ring on the downrod
with the two keyhole slots facing up toward the ceiling.
SECURING FAN TO SECONDARY SUPPORT SYSTEM
Safety
cable
Drive a wood screw (AA) and spring washer (CC) and flat washer (DD) into the side of the brace that holds the outlet box. Leave the 3 mm (1/8 inch) of
space between the support brace and washer. Insert the safety cable through the mounting bracket and one of the holes in the outlet box into the ceiling.
Adjust the length of the safety cable to reach the screw and washers by pulling the extra cable through the cable clamp until the overall length is correct,
put the end of the cable back through the cable clamp, forming a loop at the end of the cable.Tighten the cable clamp securely. Now put the loop in the end
of the safety cable over the wood screw and under the washer.Tighten the wood screw (AA) securely.Make sure the screw, washers and safety cable are
installed using the order pictured above.
PREPARING THE ELECTRICAL CONNECTIONS
If you feel you do not have enough electrical wiring knowledge
or experience, have your fan installed by a licensed electrician.
Follow the steps below to prepare the electrical connections.
After that, conform with the descriptions and diagrams on the
following pages to connect the fan to your household wiring.
Use the wire nuts supplied with your fan. Secure the wire nuts
with electrical tape. Make sure there are no loose strands or
connections.
Fan Installation
D
Spring
washer(CC)
Safety
cable
Flat
washer(DD)
6.
A
B
Carefully lift fan assembly and seat the hanger ball
of downrod assembly (B) onto mounting bracket (A).
Rotate fan until notch on hanger ball engages the
ridge on the mounting bracket (A).This will allow for
hands free wiring.
WARNING: Failure to properly seat the tab in
the groove could cause damage to wiring.
Wood
Safety
screw
cable
(AA)
WARNING: To avoid possible electric
shock, be sure electricity is turned
off at the main fuse box before wiring.
9
Advertisement
