Spanning-Tree Portfast - SMC Networks TIGERSWITCH 10/100 Management Manual

C L
OMMAND INE
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of a port in the
spanning-tree algorithm. If the path cost for all ports on a
switch are the same, the port with the highest priority (that is,
lowest value) will be configured as an active link in the
spanning tree.
• Where more than one port is assigned the highest priority, the
port with lowest numeric identifier will be enabled.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 0
Console(config-if)#
Related Commands
spanning-tree cost (3-116)

spanning-tree portfast

Use this command to set an interface to fast forwarding. Use the
no form to disable fast forwarding.
Syntax
spanning-tree portfast
no spanning-tree portfast
Default Setting
Disabled
3-118
I
NTERFACE