Toshiba G3 Instruction Manual page 24

Chapter 2 Installation and Wiring
6F8C1590
12
Before installing or removing the module,
WARNING
make sure that the power of the I/O base
unit to which GA932 module is installed is
turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product
WARNING
except the switches.
It may cause an electric shock.
Install it under an environment that
CAUTION
satisfies the product specifications.
When installing it under an environment that does not
satisfy the product operating temperature range, apply
forced cooling with cooling equipment.
Operating temperature range: 0 to 55°C
Before installation or wiring, remove the
CAUTION
static electricity from your body.
The static electricity accumulated in the human body may
cause failure of the product.
Do not touch the cables carelessly.
CAUTION
Applying stress to the cables may cause malfunction or
accidents.
Do not perform wiring, insertion or
CAUTION
installation of the module, removal or
replacement of the base unit while the
power is on.
It may cause an electric shock.
When installing the product to the I/O base
CAUTION
unit, do not to break or bend the pins of G3
I/O bus connector.
When it is hard to insert the module to the
CAUTION
I/O base unit, remove it and then try to
install it again rather than trying to install it
forcefully.
Use a screwdriver.
CAUTION
To prevent damage to the screws, use a screwdriver that
is suitable for the screws.
Mandatory
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited