TekTone Tek-CARE NC300II Operation, Installation And Service Manual page 56

System Configuration and Programming
50 • IL715 Tek-CARE NC300II Manual
®
Program Station Zones – Assigns a remote station to any or all zones, A through P.
1. Press the selector button for the desired station, and then press the zone
Show a Remote Station's Zones:
(blue) button. Set zones are shown on the Selector LEDs in the second and
third rows. (The second row shows zones A–J, and the first six keys of the
third row show zones K–P.)
2. Press the reset (black) button twice when finished.
1. Press the selector button for the desired station, and then press the zone
Set a Remote Station's Zones:
(blue) button. Set zones are shown on the selector button LEDs in the second
and third rows. (The second row shows zones A–J, and the first six buttons
of the third row show zones K–P.)
2. Each press of a zone's selector button toggles between adding or removing
a station from that zone, indicated by the state of that selector button's LED:
On when added to the zone, Off when removed from the zone.
NOTE: While in this programming mode, the first column of station selector
buttons indicates various settings which can be activated or deactivated.
Settings are:
0 – Paging Status On/Offline
1 – Station On/Offline
2 – Privacy On/Off
3 – Routine Call Level
4 – Personal Attention Call Level
5 – Priority Call Level
3. Press the reset (black) button twice when finished.
Station On/Offline – Allows user to activate or deactivate a remote station.
1. Press the selector button for the desired station, and then press the zone (blue)
button. The LED of the selector button marked "1" indicates on/offline status.
2. Press the 1 button to toggle the station status on/offline.
3. Press the reset (black) button twice when finished.
Assign Master Zones – This function controls which zones the master receives calls
from. Any or all zones (A through P) may be assigned to each master station. NOTE:
If all zones are deactivated, the master station will not receive any calls! Only
1. Push the zone (blue) button. Master's zones are indicated by the LED status of the
qualified personnel may make changes to these settings!
selector keys in the second and third rows. Zones A–J are shown on the second
row; zones K–P are shown on the first six keys of the third row.
2. To add or remove a zone from the master, press the zone's key to toggle its status.
3. Press the reset (black) button when finished.
Master Station Key-Press Tones On/Off – This function controls the reassurance tone
emitted for each key press on the master station. To turn this feature on or off:
1. Press the zone (blue) button.
2. Press the 0 button to toggle key-press tones on/off.
3. Press the reset (black) button when finished.
Toggle Pre-Announce Tones – This function controls the pre-announce tone emitted
from the patient station when an audio path is established. To turn this feature on
or off:
1. Press the zone (blue) button.
2. Press the 1 button to toggle preannounce tones on/off.
3. Press the reset (black) button when finished.
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.