TekTone Tek-CARE NC300II Operation, Installation And Service Manual page 23

System Operating Instructions
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
1. Press the selector button for the desired room and pick up the handset or push
Place a Call:
the talk (gray) button. If the pre-announce tone is enabled, a one-second tone
will be heard when the talk button is pressed or when the handset is picked
up. If the station is already in communication with another master, the "TALK
LED" will flash on the master to indicate that the port is busy.
2. Press talk when speaking and release to listen, or if using the handset then
speak and listen as desired.
3. Press the reset (black) button or hang up the handset when finished.
This function can be activated if other calls are waiting, but will be overridden by
higher priority calls. If the patient station being called is in privacy mode, then the
master station will not be able to listen to the room station.
1. Press the page (violet) button on the master. LEDs in the first row of selector
Place a Call to Another Master Station:
keys will light to show which masters are connected to the system. Press the
selector key for the desired master.
2. Press talk when speaking and release to listen, or if using the handset then
speak and listen as desired.
3. Press the reset (black) button or hang up the handset when finished.
Receive a Call from Another Master Station – See
1. Press the selector button for the desired room, and then press the staff (green) button.
Request or Cancel Staff Service:
2. Press the reset (black) button when finished.
A Staff request may also be made while communicating with a room by pressing
the staff (green) button. Once a request is made, the room location will indicate a
service call until it has been answered. If the overtime feature has been set (requires
NC304-series or NC305LCD master station), Staff requests will trigger call placement
to the master station when they exceed the overtime limit. See
for details on responding to Staff requests. If an SF250 or SF350B is
Station Operation (Figure 18)
not in use on the system, staff members can cancel service requests by pressing the
(Figure 17)
reset button on the associated patient station.
1. Press the staff (green) button.
Display Staff Presence and Service Requests:
2. Rooms with Staff Presence are indicated by slow flashing selector LEDs.
3. Rooms with Service Request set are indicated by rapid flashing selector LEDs.
4. Press the reset (black) button when finished.
1. Press the selector button for the desired room, and then press the staff (green)
Request or Cancel Stat Service:
button twice rapidly. Or, while communicating with a room, press the staff
(green) button twice rapidly.
2. Press the reset (black) button when finished.
Answer a Call Automatically
or
SF350B Nurse/Aide Presence Station Operation
IL715 Tek-CARE
above.
SF250 Staff Presence
NC300II Manual • 17
®