TekTone Tek-CARE NC300II Operation, Installation And Service Manual page 40

System Configuration and Programming
34 • IL715 Tek-CARE NC300II Manual
®
Diagnostics Menu – Press menu, and then press 4. This menu provides diagnostic
functions for system troubleshooting.
1 View System Masters – This function displays an information box that displays
master status indicators. Up to 8 master stations can be connected to a system, and
they are designated 1 through 8. The status of each is indicated as described by the
information box's legend.
2 View Station Poll Cycle – This function displays incoming call debugging
information from patient stations in a coded format. This data is useful to factory
personnel under some troubleshooting circumstances.
3 About Software Versions – This function displays the three versions of software
on the nurse call system. They are the MAIN.EXE file (in the nurses' master station),
the CENTRAL.BIN file (in the central equipment) and the POLLING.BIN file (in the
central equipment). These are the software components that can be upgraded in
the field.
5 Check Dialing Method – This function displays the enabled dialing method:
normal, 3-digit, or 4-digit.
Master Programming – Press menu, press 2 and then press 1. This menu provides access to
functions for the master station. These must be set individually for each master station at
the master station's location. Each menu item displays the master station's information
box, and the chosen item will already be selected. The user can then make changes to
that field as desired. On-screen instructions are also provided to guide the user.
1 Set Master ID – This allows the user to set the address number of the master
station. Master station addresses are 1 through 8.
2 Key Press Tones On/Off – This function controls the reassurance tone emitted
for each key press on the master station.
3 Toggle Pre-Announce Tones – This function controls the pre-announce tone
emitted from the patient station when an audio path is established.
4 Assign Master Zones – This function controls which zones the master receives
calls from. Any or all zones (A through P) may be assigned to each master station.
NOTE: If all zones are deactivated, the master station will not receive any calls!
5 Assign Call Responses – This function controls the types of calls the master
Only qualified personnel may make changes to these settings!
station will see for the zones that have been assigned to it. Any or all may be active
or inactive. NOTE: Critical call types, such as Code Call, can be disabled by this
6 Offline Data to Central – This function sends custom call label settings from an offline
function! Only qualified personnel may make changes to these settings!
programmed master station to the central equipment for system use. Users must
perform this function when a master station has had offline programming performed.
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.