Table of Contents
Advertisement
Quick Start Guide Rev. 0.1
Get more information about the possibilities and commands, in Thread
networks, with the commands help and help thr.
Take care that there is always a CR-LF sign at the drop down menu
send on enter in the section Input control of HTerm or similar terminal
programs.
Please note that there is no thermistor mounted on the PAN4620-ETU. Just
the software is prepared for this use case. To measure a correct temperature,
it is recommended, to use the "thermistor measuring circuit" shown in "FRDM-
KW41Z Freedom Development Board User's Guide" (in chapter "Thermistor").
The chosen Thread software example gives additionally the possibility, to use
touch sensitive inputs on the Pins "PTC16 (TSI0_CH4)" and "PTC17
(TSI0_CH5)". If PAN4620 Evaluation Board is delivered with already mounted
pin headers for "JP2" and "JP5", notice that these inputs can detect the human
body by contact and affect the software.
PAN4620
4 Getting Started
Page 23
Advertisement
Table of Contents
