Related Manuals for Panasonic PAN1781
Summary of Contents for Panasonic PAN1781
- Page 1 PAN1781 ® Bluetooth Low Energy Module Module Integration Guide Rev. 1.1 Wireless Connectivity...
- Page 2 PAN1781 Bluetooth Module Overview Bluetooth • LE 2 Mbps high speed PHY, LE long range coded The PAN1781 is a Bluetooth 5.1 Low Energy (LE) module based on the Nordic nRF52820 single chip • LE advertising extensions (advertising on controller. 40 channels total) •...
- Page 3 Panasonic Industrial Devices Europe GmbH (Panasonic) reserves the right to make changes as required at any time without notification. Please consult the most recently issued Module Integration Guide before initiating or completing a design.
- Page 4 To the maximum extent allowable by Law Panasonic assumes no liability whatsoever including without limitation, indirect, consequential, special, or incidental damages or loss, including without limitation loss of profits, loss of opportunities, business interruption, and loss of data.
-
Page 5: Table Of Contents
Purpose and Audience ......................6 Revision History ......................... 6 Use of Symbols ......................... 6 Related Documents ........................7 Overview .............................. 8 PAN1781 Module ..........................9 Block Diagram ........................... 9 Footprint ..........................10 Placement ..........................11 Regulatory and Certification Information ..................13 General Certification Information ..................... -
Page 6: About This Document
1 About This Document 1.1 Purpose and Audience This Module Integration Guide is intended to support the easy integration of the PAN1781 into a product and to ensure the compliance with regulatory requirements. It gives an overview about the hardware design requirements It is intended for hardware design, application, and Original Equipment Manufacturers (OEM) engineers. -
Page 7: Related Documents
The message Failed to save your data is displayed. Enter the value Product 123. Indicates a key on the keyboard, e.g. F10 . 1.4 Related Documents 5.2 Product For related documents please refer to the Panasonic website Information. Module Integration Guide Rev. 1.1 Page 7 of 26... -
Page 8: Overview
PAN1781 Bluetooth Module 2 Overview 2 Overview The PAN1781 is a Bluetooth 5.1 Low Energy (LE) module based on the Nordic nRF52820 single chip controller. The Bluetooth 5.1 features additionally a higher symbol rate of 2 Mbps using the high speed LE 2M PHY or a significantly longer range using the LE coded PHY at 500 kb/s or 125 kb/s. -
Page 9: Pan1781 Module
PAN1781 Bluetooth Module 3 PAN1781 Module 3 PAN1781 Module 3.1 Block Diagram PAN1781 â 1.7 V to 3.6 V Bluetooth Low Energy 5.1 Module 2.5 V to 5.5 V Nordic nRF52820 Reset DC-DC Conversion GPIOs... -
Page 10: Footprint
PAN1781 Bluetooth Module 3 PAN1781 Module 3.2 Footprint The dimensions are in millimeters. The outer dimensions have a tolerance of ±0.3 mm. Top View 3.00 1.00 0.60 1.20 2.40 5.00 15.60 Module Integration Guide Rev. 1.1 Page 10 of 26... -
Page 11: Placement
✓ Keep this module away from other high frequency circuits. ✓ Refer to the recommended pattern when designing a board. The antenna requires a cutout area of 5 mm × 3 mm under the PAN1781 module. This “Keep out Area” shall be located in every layer under the module antenna. - Page 12 PAN1781 Bluetooth Module 3 PAN1781 Module All dimensions are in millimeters. Use a ground plane in the area surrounding the module wherever possible. It is recommended to place the module: • In the center (horizontal) of mother PCB. •...
-
Page 13: Regulatory And Certification Information
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Panasonic Industrial Devices Europe GmbH may void the user's authority to operate the equipment. Module Integration Guide Rev. 1.1... - Page 14 The end product must in any case be labelled on the exterior with: "Contains FCC ID: T7V1781" Due to the PAN1781 model size, the FCC identifier is displayed in the installation instruction only and it cannot be displayed readable on the module’s label due to the limited size.
- Page 15 The radiated output power of the PAN1781 with a mounted ceramic antenna (FCC ID: T7V1781) is below the FCC radio frequency exposure limits. Nevertheless, the PAN1781 shall be used in such a manner that the potential for human contact during normal operation is minimized.
-
Page 16: Innovation, Science, And Economic Development (Ised) For Canada
The end customer has to assure that the device has a distance of more than 10 mm from the human body under all circumstances. If the end customer application intends to use the PAN1781 in a distance smaller 10 mm from the human body, SAR evaluation has to be repeated by the OEM. - Page 17 Le client final doit s'assurer que l'appareil se trouve en toutes circonstances à une distance de plus de 10 mm du corps humain. Si le client final envisage une application nécessitant d'utiliser le PAN1781 à une distance inférieure à 10 mm du corps humain, alors le FEO doit répéter l'évaluation DAS.
- Page 18 The following IC notice has to be printed in English and French in the OEM end product user information: English The device PAN1781, including the integrated antenna mentioned in 4.2.5 Approved Antenna List, complies with Canada RSS-GEN Rules. The device meets the requirements for modular transmitter approval as detailed in RSS-Gen.
- Page 19 Panasonic IC identifier for this product as well as the IC Notice above. The IC identifier is: IC: 216Q-1781 This IC identifier is valid for the PAN1781 module. In any case, the end product must be labelled on the exterior with: "Contains IC: 216Q-1781”...
-
Page 20: European Conformity According To Red (2014/53/Eu)
The end customer equipment must meet the actual Safety/Health requirements according to RED. PAN1781 and its model versions in the specified reference design can be used in all countries of the European Economic Area (Member States of the EU, European Free Trade Association States [Iceland, Liechtenstein, Norway]), Monaco, San Marino, Andorra, and Turkey. -
Page 21: Japanese Radio Law Compliance
The following models are qualified for the Japanese market: MIC ID: [R]202-DGJ063 Since the printable area on the PAN1781 is too small to show the MIC logo and the MIC ID, this information is placed on the package and in the user information. -
Page 22: China (Label Requirements)
4 Regulatory and Certification Information 4.6 China (Label Requirements) The PAN1781 has a Modular CMIIT certification. The OEM must ensure that SRRC labelling requirements are met. This includes a clearly visible label on the outside of the OEM enclosure specifying the appropriate Panasonic SRRC identifier for this module. -
Page 23: Korea (Label Requirements)
4 Regulatory and Certification Information 4.7 Korea (Label Requirements) Since the printable area on the PAN1781 is too small to show the KC logo and ID, this information is placed on the package and in the user information. The OEM must ensure KC marking requirements. The integrator of the module should refer to the labeling requirements for Korea available on the Korea Communications Commission (KCC) website. -
Page 24: Australia And New Zealand Conformity According To Rcm
PAN1781 Bluetooth Module 4 Regulatory and Certification Information 4.8 Australia and New Zealand Conformity according to RCM This Suppliers Declaration of Conformity (SDoC) is also valid for Australia. Supplier’s Details 4.8.1 Name Microsystem Support Limited New Zealand (Physical Address) -
Page 25: Bluetooth
For Bluetooth end products which integrate the PAN1781 the OEM needs to apply for an own end product listing (EPL) at the Bluetooth SIG. If the PAN1781 is used on more than one OEM product, costs can be saved by applying for a family EPL. -
Page 26: Contact Details
PAN1781 Bluetooth Module 5 Contact Details 5 Contact Details 5.1 Contact Us Please contact your local Panasonic Sales office for details on additional product options and services: For Panasonic Sales assistance in the EU, visit https://eu.industrial.panasonic.com/about-us/contact-us Email: wireless@eu.panasonic.com For Panasonic Sales assistance in North America, visit the Panasonic website “Sales &...