Table of Contents
Advertisement
Jumper
Topview
J4
J8
J9
J7, J10
J11
R32, R48
SW2, SW3
Quick Start Guide Rev. 0.1
Description
SWD connected
SWD disconnected
Module UART
connected
Module UART
disconnected
Module VCC connected Module VCC connection and GND pin. The
FTDI connected to
module UART
Breakout pin connected
to module UART
3.3 V are supplied to
the breakout pin
3.3 V are not supplied
to the breakout pin
After each different configuration the reset button needs to be pressed.
3 PAN4620 USB Evaluation-Board Overview
Detail
Access to module and programmer SWD.
Access to module UART RX and TX.
module VCC jumper can be removed for current
measurements.
Option for module UART to breakout pin or
FTDI. Place jumpers either on J7 or J10.
Option to power an external sensor board
sensor with 3.3 V. Do not place this jumper, if
an external 3.3 V source is present.
These 0 Ω resistors can be removed, to
disconnect the LEDs in case the IOs PTB0,
PTC1, PTA18, and PTA19 shall be used for
other purposes.
If you want to use PTC4 and PTC5 for other
purposes, do not push the buttons.
PAN4620
Page 10
Advertisement
Table of Contents
