Backshell Assembly Parts................................................................................................................................ 4-2

4.3

Shielded Cable Preparation ............................................................................................................................ 4-3

4.4

Connector and Backshell Assembly ................................................................................................................ 4-5

4.5

Configuration Module Installation.................................................................................................................. 4-8

4.6

Coax Cable Installation ................................................................................................................................ 4-10

4.7

Equipment Rack Installation ......................................................................................................................... 4-10

4.7.1

Panel Mount Units................................................................................................................................. 4-10

4.7.2

Standard Remote Mount Units .............................................................................................................. 4-11

4.7.3

Vertical Remote Mount Units................................................................................................................. 4-11

4.7.4

GX000 Integrated Flight Decks .............................................................................................................. 4-11

4.7.5 GAE Installation........................................................................................................................................ 4-11

4.8

Panel and Standard Remote Mount Unit Installation and Removal................................................................ 4-13

4.9

Vertical Remote Mount Unit Installation and Removal .................................................................................. 4-14

4.1

Wire Harness Installation

All electrical connections, except for the antenna(s) and shield grounds, are made through the D-sub connectors on the

rear of the unit. The shield grounds terminate to the connector backshells.

For additional information:

• For rear connector pinout and descriptions of interface connections refer to section 5

• For interconnect diagrams, refer to appendix D

• For special tools, refer to section 3.15