Parts List - Champion R15B Operation & Maintenance Manual

EXPLANATION OF TROUBLE SHOOTING GUIDE (CONT'D.)
17/18. Before servicing check valve, be sure pressure in tank is ZERO. Replace check valve.
19. Badly worn compressors which are pumping oil may deposit carbon within after-cooler tube and check
valve, restricting flow of air and possibly plugging these parts completely. These parts should be
cleaned or replaced.
Disconnect unit from power source and relieve tank pressure before servicing these components.
20. Motor pulley and flywheel must be in line to prevent wear on sides of belts. If misaligned, disconnect
unit from power source and move pulley in or out by loosening set screw on key and tapping pulley
in appropriate direction.
21. Intake filter should be cleaned periodically to allow unrestricted flow of entering air. To service filter,
remove wing nut, metal cover and filter element. Element may be blown clean with an air nozzle if
moderately dusty. Heavily fouled elements should be replaced. Never clean element with fuel oil,
gasoline or flammable solvent.
22. Cool running and long life can be assured by careful attention to crankcase oil. Check frequently and
change as indicated on compressor data sheet.
_____________________________________________________________________________
Disconnect power source before adjusting pulley.

PARTS LIST

MAJOR COMPRESSOR UNIT COMPONENTS
WARNING
WARNING
Parts common to all models except base mounted :
7) Pressure Switch
8) Pressure Relief Valve -
9) Pressure Gauge
10) Drain Valve
11) Check Valve
12) Tank Drain
13) Belt Guard
(All units except those equipped with air-cooled
aftercoolers)
Additional parts for Duplex Unit (Not Shown)
• Alternator Class 47, 208V, 3 Phase; P10043A
• Magnetic Starter (2), Specify Voltage & Phase
16
- M1227
M2843
- M519C
- M2684
- P05822A
- Z1542 - Horizontal Tank
- Z1541 - Vertical Tank
- Z-307
230V, 3 Phase; P05814A
460V, 3 Phase; P05815A